Below are some simple instructions on how to fit your Video In Motion interface.

All information given here is for a guideing purposes only. Bell Auto Services will not be held responsible for any damaged caused to your car while following these guildline instructions. Larger pictures available in PDFformat.


The tools you will need are a plastic trim removal tool or simlar, and a T20 and T30 Torx screwdriver or simlar. (examples below)



1: Remove dash end trim panal and two T30 Torx screws.

2: Remove centre console left edge trim and lower dashboard screw.



3: Remove centre console right edge trim and lower dashboard screw.



4: Pull forward the instrument cluster lower panel.



4A:The panel has four clips per side holding it on as seen below.



5: Pull forward the cluster panel to view the two screws behind and at the side.



6: Remove the final two T30 torx screws to allow the centre dash to be removed.



6A: Remove electrical connection to dash switches.



7: Remove four T20 Torx screws from nav screen, behind you will find the connecting plug where we install the module.



8: Remove the connector from the main nav unit and refit with the connector on the TV-In-Motion unit, The removed connector will connect to the remaining connector on the Tv-In-Motion unit.

9: Refit in reverse order.

For larger pictures please view PDF File!